vvdi2 authorization
If you have VVDI2 with BMW OBD Function, and Ikeycutter Condor, then can open this function
VVDI2 BMW FEM & BDC Functions Authorization Service With Ikeycutter Condor is a one of our vvdi2 authorization Tools, you can buy VVDI2 BMW FEM & BDC Functions Authorization Service With Ikeycutter Condor from svcidiag.com.
Wholesale Top quality VAS6154, GM Tech2, VCM II For Ford, Handy Baby II Car Key Chip Copier, CDP DS150
images of VVDI2 BMW FEM & BDC Functions Authorization Service With Ikeycutter Condor
Note: VVDI2 now add BMW FEM & BDC functions, VVDI2 Must have BMW OBD Function(SV86-3), then can open this function.
There are two ways to get this function:
1.If you have VVDI2 with BMW OBD Function, and Ikeycutter Condor, then you can buy this authorization.
2.If you only have VVDI2 with BMW OBD Function, then you need to pay 800USD to get this authorization(SV86-S1).
2.If you want other BMW FEM BDC Key Programmer, you can choose YH BMW FEM (SK226) on our site.
VVDI2 - BMW FEM/BDC system(function released and available, just no user manual)
Users can refer to following information (3 steps for make keys: get key info->programming FEM/BDC system->make keys)
1.support make new key with ignition switch(support add spare key and all key lost, all key lost require ISN)
2.support reset FEM/BDC KM(cluster require reset manually)
3.support erase key(after erase the key position become blank position)
4.support backup coding
5.support restore coding
Notes:
1.backup coding and restore coding can direct operation generally.
2.add keys, reset KM, erase key must programming FEM/BDC system first
3.in FEM/BDC interface, if 'get key info' the type not support, it will show: customer should use "BMW E-sys software" program FEM/BDC system. then programming FEM/BDC system with VVDI2-BMW
4.when operation on 'programming FEM/BDC system'interface, please don't close this software window until all procedures completed.
5.programming FEM/BDC system, require soldering and get eeprom.（FEM 95128 chip, BDC 95256 chip）usually there are 2 same chips on the module, please refer to the software diagram, select the correct one.
6.programming FEM/BDC system, must restore the original eeprom, restore coding. if cannot restore coding or after restore coding assemble FEM/BDC module back to car, but with problem(such as the remote control cannot start the car
or the car with window problem)please use "BMW E-sys software" coding for FEM/BDC system
7.if connect power to FEM/BDC module, but the relay keep ringing, please contact technical support for help. usually operation on FEM/BDC should be ok, just need to programming.
Go to Buy: VVDI2 BMW FEM & BDC Functions Authorization Service With Ikeycutter Condor