Cheap AdBlueOBD2 Emulator For MAN Trucks Override ADBlue System Instantly
Cheap adBlueOBD2 Emulator for MAN Trucks1.Ready for use via OBD2 port!2.Drive your truck without Diesel Exhaust Fluid!3.You can use this device, if you are unable to find a station to fuel up your adBlue/DEF tank.
UKOBD2 Provide top quality Cheap AdBlueOBD2 Emulator For MAN Trucks Override ADBlue System Instantly, if you need Cheap AdBlueOBD2 Emulator For MAN Trucks Override ADBlue System Instantly, or have any questions about Cheap AdBlueOBD2 Emulator For MAN Trucks Override ADBlue System Instantly, welcome to contact us.
Wholesale Top quality VAS6154, GM Tech2, VCM II For Ford, Porsche Piwis III, USB Link 2, Scania VCI3, CAN Clip, wiTech MicroPod 2, T300 key programmer, locksmith tools
images of Cheap AdBlueOBD2 Emulator For MAN Trucks Override ADBlue System Instantly
Cheap adBlueOBD2 Emulator for MAN Trucks
adBlueOBD2 emulator for MAN Trucks is a Plug & Drive Ready device to mulate working adBlue systems and NOx sensors on trucks, which equipped with EURO 4/5/6 catalytic converter systems, even with damaged adBlue SCR system.
AdBlue/DEF (Diesel Exhaust Fluid) is used to reduce NOx emissions in vehicles. We recommend you to use adBlue/DEF fuel. You can use this device, if you are unable to find a station to fuel up your adBlue/DEF tank.
Top 5 Reasons to Get AdblueOBD2 Emulator for MAN Trucks:
1. adBlueOBD2 is very easy to install. Just Plug it into OBD2 connector of truck or bus and remove the fuses mentioned.
2. adBlueOBD2 will override ADBlue system instantly, it will stop the usage of adBlue liquid and disable Nox sensors.
3. Without any power loss of the engine or any warnings on the dashboard and in diagnostic system.
4. adBlueOBD2 does not damage the engine and not cause any negative effects to the truck factory setting.
5. adBlueOBD2 does not change any of the settings permanently. To turn back to the truck's original settings, just unplug adBlueOBD2 from OBD2 connector.
Installation and Calibration for MAN Trucks:
1. Pull the Key out from the ignition.
2. Remove the following Fuses (MAN)
894 - 737 - 738
3. Plug adBlueOBD2 into OBD2 connector
4. Turn on the ignition and check the level of adBlue, if it shows 50% or 70%.
5. If any fault light appears on dashboard, delete via service scanner.
Package including:
1pc x adBlueOBD2 Emulator Box Interface
Go to Buy: Cheap AdBlueOBD2 Emulator For MAN Trucks Override ADBlue System Instantly