Cheap Ad-BlueOBD2 Emulator For FORD Override Ad-Blue System Instantly

1.OBD2 Plug and Drive Ready Device with competitive price!2.Drive your truck without Diesel Exhaust Fluid!3.AD-BlueOBD2 is very easy to install. Just Plug it into OBD2 connector of truck or bus and remove the fuses mentioned.

UKOBD2 Provide top quality Cheap Ad-BlueOBD2 Emulator For FORD Override Ad-Blue System Instantly, if you need Cheap Ad-BlueOBD2 Emulator For FORD Override Ad-Blue System Instantly, or have any questions about Cheap Ad-BlueOBD2 Emulator For FORD Override Ad-Blue System Instantly, welcome to contact us.

Wholesale Top quality VAS6154, GM Tech2, VCM II For Ford, Porsche Piwis III, USB Link 2, Scania VCI3, CAN Clip, wiTech MicroPod 2, T300 key programmer, locksmith tools

images of Cheap Ad-BlueOBD2 Emulator For FORD Override Ad-Blue System Instantly

Cheap Ad-BlueOBD2 Emulator for FORD

Ad-BlueOBD2 Emulator for Ford Trucks Description:

Ad-BlueOBD2 is a Plug&Drive Ready device to mulate working ad-Blue systems and NOx sensors on trucks, which equipped with EURO 4/5/6 catalytic converter systems, even with damaged ad-Blue SCR system.dBlueOBD2 is easy to install.

Ad-Blue/DEF (Diesel Exhaust Fluid) is used to reduce NOx emissions in vehicles. We recommend you to use ad-Blue/DEF fuel. You can use this device, if you are unable to find a station to fuel up your ad-Blue/DEF tank.

Top 5 Reasons to Get Ad-blueOBD2 Emulator for Ford Trucks:

1. AD-BlueOBD2 is very easy to install. Just Plug it into OBD2 connector of truck or bus and remove the fuses mentioned.
2. AD-BlueOBD2 will override AD-Blue system instantly, it will stop the usage of ad-Blue liquid and disable Nox sensors.
3. Without any power loss of the engine or any warnings on the dashboard and in diagnostic system.
4. AD-BlueOBD2 does not damage the engine and not cause any negative effects to the truck factory setting.
5. AD-BlueOBD2 does not change any of the settings permanently. To turn back to the truck's original settings, just unplug ad-BlueOBD2 from OBD2 connector.

Installation and Calibration for Ford Trucks:

1. Pull the Key out from the ignition.
2. Remove the following Fuses (FORD)
Terminal - 15
Terminal - 30
3. Plug ad-BlueOBD2 into OBD2 connector
4. Turn on the ignition and check the level of ad-Blue, if it shows 50% or 70%.
5. If any fault light appears on dashboard, delete via service scanner.

Package including:

1pc x Ad-BlueOBD2 Emulator Box Interface

Go to Buy: Cheap Ad-BlueOBD2 Emulator For FORD Override Ad-Blue System Instantly