Before tire pressure monitoring system works normally properly, the body control module will record ID information of each position in the tire pressure sensor.
Please use the following methods to read the tire pressure sensor after replacing a tire or wheel speed sensor.

Step 1 - Enter learning mode

Set the gearshift lever to "P"
Put the ignition switch to “ON”
Enter the interface of tire pressure display by DIC
DIC shows "Press Set / Ctrl to re-learn"
Press “Set / Ctrl”
The turn signal light is on for 3 seconds and the horn beep sound twice to enter the learning mode.

Step 2 - Read tire pressure sensor information

Starting from the front-left wheel,
Make the J-46079 or Diagnostic Tool EL-50448 antenna up against the valve core position & close to the rim of the tire sidewall
EL-50448 tire pressure tool is activated by start switch
After the horn sounds once, the tire pressure sensor information is successfully read

Step 3 - Same method to read other tire pressure information

Follow the instruction above to read tire pressure of the front-right, rear-right, rear-left wheels.
Turn signals is lighted for 3 seconds and the horn beeps twice when the learning is complete.

Vehicle Coverage:

2010 Buick Excelle
2010 Buick Regal (China)

Package includes:

Tags: EL-50448, AUGOCOM EL-50448 , AUGOCOM tpms , EL-50448 tpms tool

Prev: AUGOCOM CAMSHAFT ALIGNMENT Engine Timing Tool Kit For BMW N40 N45

Next: SATlink WS-6906 Professional Digital Satellite Signal Finder Meter